×
Notice
The forum is in read only mode.
Forum
Telephony Cards Support
A400/800/1200 Series
ZT_CHANCONFIG failed on channel 1
×
Questions about A400/800/1200 Analog Interface Card
ZT_CHANCONFIG failed on channel 1
17 years 10 months ago #69
by miaolin
could you give me a account on your pc so i can login on it remote to check?
i want to use ssh port 22 to login it.
17 years 10 months ago #77
by miaolin
i think you are using linux 2.6 kernel? please check the link below on patch of make zaptel work fine with udev/linux 2.6 core
www.voip-info.org/wiki/view/Asterisk+Zaptel+Installation
If you still having problem loading the zaptel try to add this on the
/etc/udev/rules.d/50-udev.rules
#zaptel
KERNEL="zapctl", NAME="zap/ctl"
KERNEL="zaptimer", NAME="zap/timer"
KERNEL="zapchannel", NAME="zap/channel"
KERNEL="zappseudo", NAME="zap/pseudo"
KERNEL="zap0-9*", NAME="zap/%n"
Topic Author
Visitor
17 years 10 months ago #83
by
I think the trouble are with hisax.
I had this...
1) mv /lib/modules/2.6.9-22.EL/kernel/drivers/isdn/hisax backup/
2) depmod -a
and
3) restart my asterisk...
4) I reconfigure the a1200p card with kudzu
5) modprobe opvxa1200 (The /dev/zap/ channels are configurated)
But.... if I do poweroff the channels don't load, if reboot don't trouble.
How can load the opvxa1200 on boot??
I have an asterisk home with Kernel 2.6.9
Best regards.
17 years 10 months ago #85
by miaolin
we already know sometime the pci id of A1200P will change after reboot on some PC, please download new driver for test
www.openvox.com.cn/downloadsFile/opvxa1200.zip
to find such issue, use lspci -v check pci id when linux can not load a1200p driver automaticly.
and another possible might caused by the udev,
my test env is a 915 mb and FC5 linux + zaptel 1.2.6
after i modified the zaptel.sysconfig in zaptel dir, add following line in it:
MODULES="$MODULES opvxa1200" # OPENVOXA1200P - Modular FXS/FXO interface (1-12 ports)
then make clean; make install,
then write a correct fxsks/fxoks config in zaptel.conf
then the udev can mount the driver correctly after boot.
Topic Author
Visitor
17 years 9 months ago #91
by
Hi Miaolin,
I have the new driver installed, by the trouble is the same. I send you a loguin to access to my * by ssh.
Trouble:
The openvox load only if I do a depmod -a and reboot the system.
The openvox dont load if poweroff the system.
Best regards.
Forum
Telephony Cards Support
A400/800/1200 Series
ZT_CHANCONFIG failed on channel 1
Time to create page: 0.039 seconds